SNAP-TITE 1.5 TRIMS 

These are the recommended trims to use with SNAP-TITE 1.5 panels:

MERC3 - RIDGE CAP

  • Allows for approximately 6″ of coverage

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.39.18 PM.png

MEPC2 - PEAK CAP

  • Allows for approximately 6″ of coverage

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.39.25 PM.png

MEGF4 - GABLE FLASHING

  • Allows for approximately 2.125″ of coverage

MEEF1 - EAVE FLASHING

  • Allows for approximately 4.625″ of roof coverage and 2″ of wall coverage

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.39.44 PM.png

MEEF2 - EAVE FLASHING

  • Allows for approximately 4.375″ of roof coverage and 3.25″ of wall coverage

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.39.51 PM.png

MEEW1 - ENDWALL FLASHING

  • Recommended to use outside closures

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.39.57 PM.png

MESW3 - SIDEWALL FLASHING

  • Allows for approximately 4″ of coverage

Screen Shot 2020-04-02 at 7.00.25 PM.png

MEVF1 - 'W' VALLEY FLASHING

  • Allows for approximately 11″ of coverage

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.40.08 PM.png

MEVF2 - 'W' VALLEY FLASHING

  • Allows for approximately 17″ of coverage

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.40.14 PM.png

MEZBAR1 - Z-BAR

  • Also available vented (MEZBAR1V)

Screen Shot 2020-04-02 at 6.40.21 PM.png

MESB1 - SNOW BREAK FLASHING

Screen Shot 2020-04-02 at 6.40.27 PM.png

METF1 - PITCH BREAK

  • Can be bent to match roof pitch, which must be specified at time of ordering

Screen Shot 2020-04-02 at 6.40.32 PM.png