MELFORT OFFICE
1km West of Junction
Highways 3, 6, & 41
306-752-4219
YORKTON OFFICE
1 mile East of Junction Highways 9 & 10
306-782-1392
STANDING (MECHANICAL) SEAM 1.5 TRIMS
These are the recommended trims to use with Standing (Mechanical) Seam 1.5 panels:
MERC3 - RIDGE CAP
-
Allows for approximately 6″ of coverage
-
Can be bent to match roof pitch, which must be specified at time of ordering

MEPC2 - PEAK CAP
-
Allows for approximately 6″ of coverage
-
Can be bent to match roof pitch, which must be specified at time of ordering

MEGF4 - GABLE FLASHING
-
Allows for approximately 2.125″ of coverage

MEEF1 - EAVE FLASHING
-
Allows for approximately 4.625″ of roof coverage and 2″ of wall coverage
-
Can be bent to match roof pitch, which must be specified at time of ordering

MEEW1 - ENDWALL FLASHING
-
Recommended to use outside closures
-
Can be bent to match roof pitch, which must be specified at time of ordering

MESW3 - SIDEWALL FLASHING
-
Allows for approximately 4″ of coverage

MEVF2 - 'W' VALLEY FLASHING
-
Allows for approximately 17″ of coverage
-
Can be bent to match roof pitch, which must be specified at time of ordering

MEZBAR2 - Z-BAR
-
Also available vented (MEZBAR2V)

MESB1 - SNOW BREAK FLASHING

METF1 - PITCH BREAK
-
Can be bent to match roof pitch, which must be specified at time of ordering
